Description
This Sandvik D55SP drill, located in Western Australia, is in excellent condition after undergoing a full and comprehensive ground-up rebuild in 2017. The rebuild resulted in an enhanced system with better-quality pumps and motors that provide more power and pressure. Additionally, a state-of-the-art electronics system was installed for full system monitoring and a superior engine management system was put in place, allowing the operator to have real-time updates on the engine and hydraulic system temperatures and fuel consumption reports.
We have included photos of the drill from 2017 when the rebuild was just finished, so you can see the quality of the work done. A full specification on this drill, as well as a Sandvik standard D55SP specification document, can be found under the documents tab.
Sandvik D55SP Technical Data
Hole diameter
172mm-254mm (6¾” – 10”)
Drill pipe
7.62m (25’)
Hole depth extension)
17m (55’) single pass (+ 15.2m (50’)
Undercarriage
330SL class excavator
Max pull-down
200 kN (45,000 lbf)
Bit load
232 kN (52,000 lbf)
Engine
597 kW (800hp)
Compressor
345.3 m/min (1600 scfm) 6.9 bar (100PSI)
Feed rate
0-35.4m/min (0-116 fpm)
Hoist rate
0-61.6 m/min (0-202 fpm)
Rotation speed
0-131 RPM
Rotation torque
9934 Nm (88,000 in-lb)
Operating weight
79,832 kg (176,000 lb)
